Installation Manual
Reverse With Condence ™
17
TROUBLESHOOTING
Troubleshooting
Monitor Displays Blue Screen & Displays No Signal
• Do a hard reset, unplug all cables and power cables leave out for 1
minute and then reconnect them
• Check to ensure that the connection to the camera is tight
• Verify camera cable is plugged into port labeled Backup Camera trig-
ger on power harness is put to power 12v+
If the problem still persists, verify that alternate ports work.
If alternate ports do not work, remove Blue Trigger wire from
12V+ and select alternate channels.
Monitor Will Not Power-Up (no backlight on power button)
• Check fuse
• Check 12v+ to monitor
• Check ground connection
No Image On Screen
• Verify camera is on correct camera input
• Verify cable is connected to monitor
• Verify camera is connected to cable
• Connect known working camera and cable to monitor
• Verify Blue trigger is receiving power