Installation Manual

Rear View Safety

WIRING

• To power the system connect the power (RED) 12V+ wire to igni-

tion power and the ground (BLACK) wire to chassis ground.

• These are the only wires needed to power the entire system

and all the cameras. Each camera can be seen at any time by simply

pressing the power button and using the V1/2 button to toggle.

• The three positive trigger wires (WHITE-CH1, BROWNCH2, BLUE-

CH3) each represent one channel and will turn on their channel

when the trigger wire is energized with 12V.

• "Camera 3" is the designated backup channel. To have the the

backup camera come on when you go into reverse, connect the

BLUE wire to reverse power (or any power source that comes on

only in reverse).

• The other channels can similarly be triggered (i.e. side cameras

can be triggered by the turn signals etc.)

• To automatically have camera and monitor turn ON when vehicle

activates, simply twist BLUE positive trigger 12V+ to Red Power

line 12V+ and wire to ignition power.

Power Harness