Installation Manual

9
Reverse With Confidence
™
Installation Guide
Camera
1. One camera will be mounted on the tow vehicle and wired with a
direct wire the harness. The second camera is connected to the
rear of the trailer. It is connected to the quick connect wiring.
2. Attach camera bracket close to rear marker lights, centered
on vehicle (Figure 1.5 number 5).
2. Attach camera to bracket using screws provided and adjust
the angle.
Cable + Quick Connect/Disconnect Kit
1. The cable on this system is split into three parts, two camera ca-
bles that end with Quick Connect terminals and a Pigtail Cable.
2. The first camera cable (26') mounts on the tow vehicle. It runs
from the cab to the back of the tow vehicle where it is mounted
flush to the vehicle (Figure 1.5 number 2).
3. The second cable (66') mounts on the trailer. It runs from the
camera on the back of the trailer up to the front of the trailer where
it is mounted flush to the vehicle (Figure 1.5 number 3).
4. To complete the connection, just connect the Pigtail Cable to both
terminals and the circuit is complete (Figure 1.5 number 4).
Monitor
1. To Attach the Pedestal mount to the dashboard or to the headliner
using self-tapping screws and/or adhesive pad.
2. Attach monitor to mount, and adjust mounting angle to allow op-
timum driver viewing comfort. (see figure 1.1 on page 12)