Instruction Manual

Rear View Safety

Step 4: Install the main unit

• The main unit is usually put in the central control room or behind the tool box.

Step 5: Check the wiring connection before powering on

• Make sure all cables are well connected before powering on.

Step 6: Check basic function of the system

• Images from 4 cameras can be displayed on the screen

• Surround view is on the left and single view on the right

• Single view could be switched by remote if needed.

Step 7: Debug the image calibration

• For details, please refer to the Calibration Steps in next pages.

Calibration Steps

Step 1: Lay a rectangular frame around the vehicle

• Lay the lines parallel and as close as possible to the vehicle body while making sure each line could

completely be shown in the according single view;

• Zebra-strip tapes (provided as standard accessory) or rectangular laser gradienter is suggested;