Instruction Manual

9
Reverse With Confidence
™
Installation Guide
Camera & Cable
When installing the camera at the rear of the vehicle, remove the exist-
ing tailgate handle and replace with the tundra tailgate handle.
Be sure to position the cable properly. The aviation camera cable uses
aircraft grade connectors which means the camera cable can be ex-
posed to all weather elements. Do not run the cable over sharp edges,
do not kink the cable and keep away from HOT and rotating parts.
Fasten all cables and secure all excess cable. Connect camera to the
camera extension cable which runs inside the vehicle. Attach camera to
the center of the license plate are using the screws provided and adjust
the angle. Figure 1.1
Wiring
After connecting the camera to the "camera cable" the camera should
be plugged into AV2 input. Connect the RED 12V power wire to a an
ig-
nition power source and the BLACK 12V ground wire to a chassis
ground.
The GREEN wire is the REVERSE trigger wire. Connect this wire to the
vehicle’s backup light circuit to activate the rear-view image whenever
the vehicle shifts into reverse. To connect a second camera, connect it
to AV1 and it can be turned on by pressing the power button on the
monitor. Figure 1.2