Instruction Manual

Rear View Safety Reverse With Condence ™
10 11
WIRING
TOUCH SCREEN
Wiring Touch Screen Operation
Black to GND
Red to ignition +12V
Yellow to battery
to left camera
to right camera
to front camera
to back up camera
trigger line 1
trigger line 2
Green to back car singal
Wire control
10 11
TOUCH BUTTONS OPERATION
full display screen: short press to enter into “menu setting” interface
split screen: unusable
reversing:
long press to enter into “backup guide line” setting
left and right: unusable
Non-trigger state: channel switch
Non-trigger state:
Trigger state:
Trigger state: unusable
1
1
3
4
2
5
234 5
MENU SETTING
In “ full display screen” state, short press “ ” to enter into menu setting interface .“ ” and “ ” are to
change the gure of each setting.
About “WIRE CTR DELAY”
This function is used with wire control switch.
1. If "WIRE CTR DELAY" is setted "OFF", this function is same as the touch buton "CH" .
2.If "WIRE CTR DELAY'' is setted as other parameters, you switch one video screen to another one by wire control
switch, once the delay time is up, the screen will be automatically back to the pre-switching video screen.
“
”
BRIGHTNESS
50
{
{
{
short press to enter into “menu setting” interface
Non-trigger and reversing trigger state:Turn on/off screen
The others state: unusable
In menu setting state: Parameter down
In menu setting state: Parameter up
1) Non-Trigger/Reversing trigger state: Turn on/o screen | All other
states: Not used
2) Menu State: Parameter down
3) Non-Trigger State - Full screen display: Short press to enter "Menu set-
ting" interface / Split Screen: Not used
Reversing Trigger State - Reversing: Short press to enter into "menu set-
ting" interface / Long press to enter into "Grid Line" setting
Left/Right Trigger State: Not Used
4) Menu State: Parameter Up
5) Non-Trigger State: Channel switch / Trigger state: Not used