Instruction Manual OEM Frameless Rear View Replacement Mirror Monitor with 7.
NOTE! Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty. Congratulations on purchasing a Rear View Backup Camera System! TABLE OF CONTENTS 2 Rear View Safety The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle.
Please read the entire manual and follow the instructions and warnings carefully. Failure to do so can cause serious damage and/or injury, including loss of life. Be sure to obey all applicable local traffic and motor vehicle regulations as it pertains to this product. Improper installation will void manufacturer’s warranty. 4 • The Rear View Camera System is designed to help the driver safely detect people and/or objects helping to avoid damage or injury. However, you the driver, must use it properly.
If you have questions about this product, contact: Rear View Safety 1797 Atlantic Avenue Brooklyn, NY 11233 Tel: 1.800.764.1028 Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away from hot/moving parts and electrical noisy components. We recommend doing a benchmark test before installation to insure that all components are working properly.
Remove the original mirror HOW INSTALL Remove theTO original mirrorMIRROR MONITOR Original Mirrorthe Installation Remove original mirror Car factory original mirror Car factory original mirror The plate on the windshield The plate on the windshield Install mirror monitor on the plate factorymonitor original plate on the windshield Original mirrormirror plate Install Car mirror on the plateTheWindshield 1 Different cars have different brackets.
Wiring Touch Screen Operation TOUCH BUTTONS OPERATION I c 1 to left camera to right camera to front camera to back up camera 3 4 5 1)1 Non-Trigger/Reversing trigger Non-trigger and reversing trigger state:Turn on/offstate: screen Turn on/off screen | All other 2 In menu setting state: Parameter down The others state: unusable states: Not used full display screen: short press to enter into “menu setting” interface Non-trigger state: { split screen: unusable 2)3 Menu State:reversing: Parameter down
MENU SETTING In “ full display screen” state, short press “ Menu ” to enter into menu setting interface .“ ” and “ ” are to change the figure of each setting. BRIGHTNESS 50 In full display mode, short press menu to toggle options and use the About “WIRE CTR DELAY” arrow keys to change parameters. This function is used with wire control switch. Grid Lines Generally, to help drivers estimate the distance from obstacles, there are three lines for reference- red, yellow, and green.
Grid Lines Reversing State: Long press "Menu" to enter guide adjustment mode. We adjust left guide line first. Use the arrow keys to rotate the guid line counterclockwise and clockwise. Short press "Guide Line Set" to switch to next item. Adjust line with arrow keys. Press "Guide Line Set" to adjust right grid line. Counterclockwise Short Press: Next item Clockwise Longe press: save setting and exit Left Up Down Screen Size Aspect Resolution Working Voltage Signal System Operating Temperature 7.
REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND.
If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Better Cameras. Better Service. IT’S OUR GUARANTEE.
