Installation Manual

9
Reverse With Confidence
™
Installation Guide
• To power the system connect
the power (RED) 12V+ wire to
ignition power and the ground
(BLACK) wire to chassis ground.
• These are the only wires needed
to power the entire system and
all the cameras. Each camera
can be seen at any time by
simply pressing the power
button and using the V1/2
button to toggle.
• The trigger wire represents
channel 2 and will turn on when
the trigger wire is energized
with 12V.
• To automatically have camera
and monitor turn ON when
vehicle is turned on, plug
camera in channel 2 and twist
BLUE positive trigger 12V+ to
RED power line 12V+ and wire
to ignition power.
• Audio: There is continuous
audio on both channel 1 and
channel 2.
• Grid-lines: The grid-lines are
carried through the blue wire. To
use the grid-lines for reversing,
connect the blue wire to a
reverse power.
• There is a built-in voltage
regulator for our systems which
can handle 12-24 volts. Real
consumption is 10 to 30 Volts.
Note: If connecting power
directly to battery, the camera
is always ON and therefore can
drain battery. Therefore it is
recommended to connect
power to an ignition switched
accessory power source.