Manual

I/O Connections

PTZ (Pan/Tilt/Zoom)

There are three methods for setting up PTZ functionality:

1. Method 1 (Remote Control)

a) Connect the RS485 control cable of the PTZ to the RS485A

and RS485B of the MDVR, connect the video cable to the

MDVR video input, and then power the PTZ.

b) Configure the PTZ setting corresponding to PTZ data under

the peripheral setup option to use the remote control to

control the PTZ.

2. Method 2 (dedicated control unit)

a) Connect the RS485 control cable of the PTZ to 3D control

keypad.

b) Connect the video cable to the MDVR video input to power

the PTZ and 3D keypad.

c) Set keypad parameters corresponding to the PTZ.

Using a dedicated PTZ control unit may yield higher speed

and efficiency than the remote control.

3. Method 3 (both the above)

• Make the connections described for methods 1 and 2 to

enable PTZ functionality using both the remote control and

a dedicated control unit.