Instruction Manual

Reverse With Condence ™
5
• Electric shock or product
malfunction may occur if this
product is installed
incorrectly.
• Use this product within the
voltage range specied. Failure to
do so can cause electronic shock or
product malfunction.
• Take special care when cleaning
the monitor.
• Make sure to rmly ax the
product before use.
• If smoke or a burning smell is
detected, disconnect the system
immediately.
• Where the power cable may touch
a metal case, cover the cable with
friction tape. A short circuit
or disconnected wire may cause a
re.
• While installing the Rear View
System be careful with the wire
positioning in order to avoid wire
damage.
• The Rear View System should only
be used when the vehicle is in
reverse.
• Do not watch movies or operate
the monitor while driving; as it may
cause an accident.
• Do not install the monitor
where it may obstruct drivers
view or obstruct an air bag
device.
• Dropping the unit may cause
possible mechanical failure.
INSTALLATION:
SAFETY INFORMATION