Installation Manual

REAR VIEW SAFETY
8
Before Beginning Installation
Before drilling please check that no cable or wiring is on the
other side of the wall. Please clamp all wires securely to reduce
the possibility of them being damaged while vehicle is in use.
Keep all cables away from hot or moving parts and electrical
noisy components.
Step 1: Choose the monitor and camera locations.
Step 2: Install all cables in vehicle, when necessary a 0.8 (20mm)
hole should be drilled for passing camera cable through vehicles
walls. Install split grommets where applicable.
Step 3: Once all cables and wiring have been properly routed and
the system has paired, perform a system function test by tem-
porarily connecting the system. If the problem persists see trou-
bleshooting (page 20).
We recommend doing a benchmark test before installation
to insure that all components are working properly.
SYSTEM COMES PAIRED.
• But if there is no image on monitor, your system is NOT paired
and needs to be paired. (see page 10)
Before Beginning Installation