RVS-02-360-4-Calibration-Guide
Table Of Contents
- Introduction to Calibration
- Calibration Kit Components
- Placing Calibration Pads
- Connecting Peripherals for Accessing and Navigating the GUI
- Connecting a Monitor
- Verifying Calibration Pad Placement
- Logging In
- Automatically Calibrating
- Refining the Calibration
- Exiting the Calibration View
- Verifying that Calibration was Successful
- InView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 9
In this window, you can select the
measurement units, and enter the
vehicle width and length�
This step is optional�
2. Click Calibrate to start the automatic calibration process�
During the process, a series of messages appears on the screen to conrm when each calibration step is complete. If
there is a problem with completing a step, a message appears to advise that a problem has occurred�
A message will appear for each camera view announcing the successful completion of calibration for each view,
nishing with a message that the calibration was successful.
3. Click Yes to complete the procedure. The system outputs the 360 image.
NOTE: If Automatic Calibration fails
In the unlikely event that Automatic Calibration fails, please see the InView 360 HD Calibration Guide,
document number 700-1216.