RVS-02-360-4-Calibration-Guide
Table Of Contents
- Introduction to Calibration
- Calibration Kit Components
- Placing Calibration Pads
- Connecting Peripherals for Accessing and Navigating the GUI
- Connecting a Monitor
- Verifying Calibration Pad Placement
- Logging In
- Automatically Calibrating
- Refining the Calibration
- Exiting the Calibration View
- Verifying that Calibration was Successful
- InView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 6
2. Cycle through every camera view by either:
• Pressing the green DRIVER/VIEW button repeatedly, or
• Pressing the Arrows on the remote control
While reviewing the images on the monitor, ensure that the cameras have a direct line-of-sight with the calibration
pads�
The pads should not be obstructed by mirrors, ladders, or any other protruding objects�
In this image, you can see that the calibration
pad at the left is not placed correctly� It can not
be clearly seen as it is behind a door�
The calibration pads should not be
obstructed by mirrors, ladders, or any other
protruding objects�
3. Move the calibration pads further away from the vehicle if there is an obstruction blocking the pad in the camera’s
eld of view.
NOTE: Spacing the Calibration Pads
For calibration, all four pads must be an equal distance away from the vehicle� So if you move any one calibration pad,
then you must move the other three pads an equal distance away from the vehicle� See the example below�
Trial Pad Placement
6"
6"
{
{
Optimal Pad Placement
4. Cycle through the images again after you have adjusted the placement of the pads� Verify that the pads are visible
and unobstructed�