RVS-02-360-4-Calibration-Guide
Table Of Contents
- Introduction to Calibration
- Calibration Kit Components
- Placing Calibration Pads
- Connecting Peripherals for Accessing and Navigating the GUI
- Connecting a Monitor
- Verifying Calibration Pad Placement
- Logging In
- Automatically Calibrating
- Refining the Calibration
- Exiting the Calibration View
- Verifying that Calibration was Successful
- InView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 5
Connecting a Monitor
Use the VGA Out connector to connect to a monitor�
Verifying Calibration Pad Placement
Calibration pads provide reference points for the cameras during the software calibration process� Therefore, it is important
that the calibration pads are accurately and optimally placed�
1. Power up the inView 360 HD AVM system.
You should see the simulated 360° image on one side of the monitor, and channel 1 (front camera) on the other side.
Connect a USB mouse or an IR
receiver to the USB cable
Connect a monitor
to the VGA out cable