RVS-02-360-4-Calibration-Guide
Table Of Contents
- Introduction to Calibration
- Calibration Kit Components
- Placing Calibration Pads
- Connecting Peripherals for Accessing and Navigating the GUI
- Connecting a Monitor
- Verifying Calibration Pad Placement
- Logging In
- Automatically Calibrating
- Refining the Calibration
- Exiting the Calibration View
- Verifying that Calibration was Successful
- InView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 4
Correct Pad Placement
Correct Pad Orientation
Connecting Peripherals for Accessing and Navigating the GUI
You will use either USB mouse or a remote control to navigate the system's on-screen GUI to complete the automatic
calibration� To use the mouse, you will directly connect it to the InView 360. To use a remote, you will directly connect an IR
receiver to the InView 360.
When placing the calibration pads, ensure that they
are in the correct orientation� The long rectangle
should be at pointing towards the front of the vehicle�
Towards vehicle front
6"
6"
{
{
Connect a USB mouse or an IR
receiver to the USB cable