RVS-02-360-4-Calibration-Guide
Table Of Contents
- Introduction to Calibration
- Calibration Kit Components
- Placing Calibration Pads
- Connecting Peripherals for Accessing and Navigating the GUI
- Connecting a Monitor
- Verifying Calibration Pad Placement
- Logging In
- Automatically Calibrating
- Refining the Calibration
- Exiting the Calibration View
- Verifying that Calibration was Successful
- InView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 3
Introduction to Calibration
The calibration process “stitches” together images from the front, back, left, and right camera views into a 360 top-level
image of the space around the vehicle� After the physical installation of the cameras, ECU, antennas, push buttons, and
optional monitor/recorder, the inView 360 HD AVM system will have to be calibrated to optimize this 360° view. The
Automated Calibration process requires someone who is familiar with wizard-like, automated setup procedures. For the
Automated Calibration process, the person involved will have to do the following:
• Place calibration pads so that they can be viewed without obstruction�
• Rene the overlay
Placing Calibration Pads
Calibration pads provide reference points for the cameras during the software calibration process� Therefore, it is important
that the calibration pads are accurately and optimally placed�
Using the roll of police-type tape provided with the inView 360 HD AVM system kit, create a rectangular perimeter around the
vehicle, ensuring that you use perpendicular (90 degree) angles at each corner.
TIP! Calibration Pad Placement
Start by placing the calibration pads
need about 6 inches away from all
sides of the vehicle� Then check to
see if all pads are visible� If any are
blocked, then move all pads out an
equal amount away from the vehicle�
Try placing the pads 12 inches away,
and then check again�
Incorrect Tape Placement
Correct Tape Placement
Calibration Kit Components
1 x a set of four (4) calibration pads