RVS-02-360-4-Calibration-Guide

© Rear View Safety | All rights reserved
p. 10
1. Select a Vehicle Type from the drop-down menu. These vehicle types are pre-congured for the chosen vehicle's
dimensions and shape�
2. Adjust Precision eld to select the size of the incremental changes that are made when you use the - and + buttons or
the Vehicle Rotation arrows�
3. Use the - and + buttons to adjust the Vehicle Length and Width of the overlay�
4. Use the Vehicle Rotate arrows to rotate the overlay to match the vehicle shape�
5. Use the Up/Down/Left/Right arrows to correct the Offset of the overlay so that it better ts the image.
6. Click Update to assign the changes and to update the 360 overview image.
7. Click Save if you are satised with the overview image.
Rening the Calibration
Sometimes the automatic calibration process requires some ne tuning after the process. You might notice that the overlay
in the 360 image does not quite match your vehicle's dimensions.
After the automatic calibration procedure is complete, you will have access to the Automatic Calibration conguration
window, where you can rene the 360 image. You can do the following:
• Select a vehicle type
• Adjust the vehicle length and/or width
• Rotate the vehicle (similar to horizon
correction in cameras)
• Offset the image
 NOTE: When Using a Remote
You'll have to shift through each
category and use the arrow buttons
to select options if you are using the
remote control�
 NOTE: Adjusting the Points
If you are using a mouse and are not satised with the points, you can click Adjust if you want to make more
adjustments. You will get access to a point-plotting interface. This option is not accessible if you are using the remote.