Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 6
4 x Camera Modules 2.9 MP 4 x Camera Housings
1 x Y-Splitter
1 x External GPS Antenna
1 x Ethernet Adapter
1 x External Wi-Fi Antenna 1 x Dashboard Push Button
Mount/Template
3 x Push Buttons
1 x Outrigger Button Cable Harness1 x Event Button Cable Harness
(Not used during calibration.)
1 Green: Driver button
1 Black: Outrigger/Overlay
button
1 Red: Event/Panic button