Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 4
Installation Process
There are multiple steps to be performed by different team members:
1. Prepare for Installation
2. Install the inView 360 HD system
3. Calibrate the inView 360 HD system (See the inView 360 HD System Calibration Guide)
4. Verify that the inView 360 HD system was correctly installed and calibrated (See the inView 360 HD Verication and
Setup Guide)
Each step requires a specic skill set from the person who performs it.
Preparing for Installation
Kit Components
Before you begin the installation, you should check that you received all the components with your kit. If something is
missing, please contact Tech Support (see back cover).
NOTE: Extra Kit Components
The installation kit comes with several components that do not need to be installed. These components are reserved
for future uses, and can be set aside and left with the customer.
• 1 x Cable Harness
• 1 x ECU with Lock-Removable Front Cover
• 4 x Camera Modules 2.9 MP
• 4 x Camera Housings
• 4 x Camera Cable Extensions of different lengths:
• 8 m for the front camera
• 12 m for the left and right vehicle side cameras
• 15 m for the back camera
• Extra cable extensions can be ordered separately
• 1 x Y-Splitter
• 1 x Remote Control
• 2 x 4p-to-RCA Adapter Cables
• 1 x External IR Sensor Receiver
• 1 x Event Button Cable Harness
• 1 x Driver Button Cable Harness
• 1 x Outrigger Button Cable Harness
• 1 x View Select Signal Cable Harness
• 1 x External GPS Antenna
• 1 x Ethernet Adapter
• 1 x External Wi-Fi Antenna
• 3 x Push Buttons (1 green for the Driver/View button, 1
red for the Event button, and 1 black for the Outrigger
button)
• Tape in Calibration Kit
NOTE: Installation Process
This document assumes that the installer is familiar with installing hardware in a vehicle. Therefore, this document
does not go into detail to describe how to mount the ECU and cameras, and how to route the kit cables.