Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 20
inView 360 HD Customer Support
Safe Fleet Community
User documentation, training videos, and other technical resources for the InView 360 HD system
can be found on Rear View Safety’s dedicated 360 HD page :
https://www.rearviewsafety.com/inview-360-hd-around-vehicle-monitoring-system.html
Contact Us
Email: customerservice@rearviewsafety.com
Phone: 800-764-1028
Support Hours: Mon-Thu 9:00am-5:30pm, Fri 9:00am-5:00pm EST