Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 18
To connect the push buttons:
Driver/Event Button Cable
Harness
Outrigger Button Cable Harness
Dashboard Push Button
Mount/Template
Dashboard Push Button
Mount/Template
Event Button Cable Harness
Black Push
Button Switch
Green Push
Button Switch
Red Push
Button Switch
1. Find the connectors on the ECU harness.
2. Use the correct harness to connect each switch to the ECU.
3. Install the dashboard push button mount/template into the dashboard.
4. Install the push buttons in the mounting plate on the dashboard.
5. Connect the correct cable harness to the correct button. Install the
mounting plate into the dashboard.
6. Install the push buttons in the mounting plate on the dashboard.
7. Connect the correct cable harness to the correct button.