Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 17
Connecting the Push Buttons
The inView 360 HD AVM system kit comes with three push buttons that, with the use of the dashboard push button mount/
template, can be mounted in the vehicle within the driver’s reach. Although the buttons can be congured to suit each
customer’s needs, we suggest that they are congured to do the following:
Green (Driver/View) Button: The driver presses this button to cycle through the different camera views for the vehicle (front,
rear, left, top).
Red (Event) Button: The driver presses this button when an event (vehicle collision, safety issue) happens. A short video clip
(15 seconds) is created for future review and analysis.
Black (Outrigger/Overlay) Button: The driver presses
this button to deploy the Outrigger View function on their
monitor. This is only used on vehicles that have stabilizing
outriggers such as ladder and/or boom vehicles. The
Outrigger View helps drivers position such vehicles in
locations so that the outriggers can be deployed without
encountering obstacles.
Connectors on
the ECU
To connect the push buttons:
1. Find the connectors on the ECU harness.