Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 16
Instant Reverse Setup
To connect instant reverse feature:
• Split rear camera using a splitter at ECU.
• Connect one end of splitter to Rear Camera on ECU.
• Run cable from other end to the end of HD monitor
harness and connect to Camera 1.
• Run V_CTRL wire to the end of HD monitor harness
and connect to Trigger 1.
To Rear Camera