Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 15
Connecting the ECU to Up to Three Devices
Using a combination of the VGA and CVBS video lines, you can connect up to three devices of the following combinations:
• 1 x HD monitor, 1 x standard resolution monitor, and 1 x recorder
• 1 x HD monitor and 2 x standard resolution monitors
VGA
HD monitor
CVBS
Standard monitor
Y-Splitter
Additional hardware
required for connecting to
a Safe Fleet recorder or
additional monitor
OR
Safe Fleet Recorder
Second standard
monitor