Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 14
Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
If your monitor is an HD monitor, then you can connect it to the ECU via the VGA connector.
In this scenario, the system can be congured to turn off video to the HD monitor (for safety), and because the recorder is
on the separate CVBS video feed, the recording is not interrupted.
Safe Fleet
Recorder
CVBS
NOTE: Connect records to the CVBS connection only
Recorders cannot be connected to the VGA video feed.
VGA
HD monitor