Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 13
Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
A Y-Splitter can be used to split the CVSB video line to connect either a Safe Fleet recorder or a second standard
resolution monitor�
Primary monitor
(Example monitor
shown)
CVBS
Additional hardware
required for connecting to
a Safe Fleet recorder or
additional monitor
Y-Splitter
NOTE: Potential of Not Recording Video
Be aware that if you congure the system to cut the video feed when
the vehicle reaches a certain speed (a safety feature that removes
the live video feed from the in-cabin monitor so that the driver is
not distracted), this will also affect the recorder. No video will be
recorded during that time�
OR
Safe Fleet Recorder
Second standard
monitor