Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 11
Connecting Cameras to the ECU
The cameras are labeled to indicate where they should be mounted on the vehicle - FRONT, RIGHT, LEFT, REAR. When
connecting cameras to the ECU, it is important that you do the following:
• Connect the labeled camera to the correct corresponding camera interface on the ECU harness.
• Connect each camera to an extension cable before connecting it to the ECU.
NOTE: Extra Camera Ports
The inView 360 HD AVM system comes with two extra camera ports for cameras 5 and 6. Cameras connected to ports
5 and 6 are not required for the calibration procedure.
Connect the cameras as indicated in the following diagram�
For Cameras 5 & 6. Not used.
during calibration.
4 x Camera
Extension Cables
4 x Camera Units
C
o
n
n
e
c
t
t
o
C
o
n
n
e
c
t
t
o