Installation Guide
Table Of Contents
- Introduction
- Installation Process
- Preparing for Installation
- Mounting the ECU
- Routing Power, Signals, and Buttons
- Placing Cameras
- Putting the Components Together
- Connecting to the Power Source
- Connecting Cameras to the ECU
- Connecting Monitors and Recorders
- Connecting the ECU to a Standalone (Single) Monitor
- Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
- Connecting the ECU to a HD Monitor (via VGA) and a Recorder (via CVBS)
- Connecting the ECU to Up to Three Devices
- Connecting the Push Buttons
- Connecting Antennas and an IR Receiver
- Connecting to Vehicle Signals via the View Select Signal Cable Harness
- Next Steps...
- inView 360 HD Customer Support
© Rear View Safety | All rights reserved
p. 10
Putting the Components Together
Connecting to the Power Source
When connecting to the power sources, please ensure the following:
• Red goes to vehicle power
• Yellow goes to vehicle ignition
• Black goes to vehicle ground
You will have to splice fuses onto the red (vehicle power) and yellow (vehicle ignition) lines. Please ensure that the fuses are
as close to the power source as possible and that you use weather-proof fuse receptacles.
Also, it is important that the “extension” power lines are cut to length.
To battery To ignition To ground