User guide

Installing a Connector on Coax Cable

TIP: If installing the connector in hot weather,

increase dimensions by ¼”.

Strip the outer cover back ½” from the end of the cable.

Fray braid back as far as the outer cover will allow.

Trim braid close to the outer cover, and remove

¼” of inner insulation, being careful not to nick the

center conductor. Make sure no foil or braid can

touch the center conductor.

Slide the connector tip between the braid and inner

insulation (braid and foil, on foil shield cable). Push

the connector onto the cable as far as it will go.

Attach the cable with a proper crimping or

compression tool. Do not crush cable out-of-round.

FCC Guidelines

Changes or modifications not expressly approved

by Winegard could void your authority to operate

the equipment.

NOTE: This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy and,

if not installed and used in accordance with the

instructions, may cause harmful interference to

radio communications.

Warning: Do not remove dome or any

internal components without direct

instruction from Winegard Technical

Service. Removing components can

cause cable wrap to malfunction, causing

permanent damage to antenna. Do not

run antenna without the dome in place

and secured. Failure to follow these

instructions can void the product Warranty.

Page 4

Winegard Rayzar Automatic Antenna