INSTALLATION AND OPERATING INSTRUCTIONS FOR 7330B4101 SOLAR POWERED BATTERY MAINTENANCE KIT
TABLE OF CONTENTS I. II. III. IV. V. VI. VII. General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installing on 6700 Series Air Conditioners . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installing on 7000, 8000, 48000 Series Air Conditioners . . . . . . . . . . . . . . . . . . . Installing on 47000 Series Air Conditioners . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ceiling Assembly Wiring . . . . . . . . . . . . .
II. INSTALLING ON 6700 SERIES AIR CONDITIONERS WARNING – SHOCK HAZARD in the wire harness and insure that no wires can come into contact with the refrigerant copper lines or any sharp edges. To prevent the possibility of severe personal injury or equipment damage due to electrical shock, always be sure the electrical power to the appliance is disconnected. 8. Remove and discard the strain relief bushing found in the side panel (refer to Figure 1).
FIGURE 1 -4-
III. INSTALLING ON 7000, 8000 AND 48000 SERIES AIR CONDITIONERS WARNING – SHOCK HAZARD 8. Route the solar harness under the evaporator drain pan along with the system wiring harness. Wire tie the solar harness to the system wiring bundle. It will be necessary to gently pry up the drain pan to fish through the white connector plug. Take up all solar wire harness slack wire and drop the harness end into the return air opening of the basepan.
FIGURE 2 -6-
IV. INSTALLING ON 47000 SERIES AIR CONDITIONERS 6. Route the solar harness along the system wiring harness. Wire tie the harness to system wiring bundle. Take up all solar harness slack wire and drop the harness end into the return air opening of the basepan. To install the solar panel and through-way wiring of this kit to the 47000 series air conditioners, perform the following steps (refer to Figures 3 and 4). 7.
FIGURE 4 -8-
V. CEILING ASSEMBLY WIRING (ALL MODELS) 1. Remove the inside ceiling assembly shroud or grille. The ducted system grille is attached with four screws (one near each corner). Free delivery system shrouds are attached with two screws (one each end). Ducted system grille is shown in Figure 5. 2. The short wire harness assembly found with this kit must install onto the ceiling grille or shroud through the return air section. Ducted system grilles are totally in the return air stream.
VI. WIRING TO THE BATTERY In most cases, the recreational vehicle will be provided with a 12 VDC receptacle which is wired to the battery circuit, usually a cigarette lighter. Insure that during storage, when all 12 volt loads have been shut off, that the manufacturer supplied receptacle maintains a path to the battery. This fuse protects the wiring between the battery and the receptacle. (A ½ amp fuse is provided in the male plug on the 20’ connector cable assembly to protect wiring to the solar panel.
During daylight hours, unplug the charger. Performance Limitations Your solar maintenance system is designed to generate enough power to maintain the charge on your house battery at its last operated charge value only during storage when all devices and appliances are off (or when so equipped, the battery disconnect is activated). It will not maintain the charge on a battery which is subject to discharge by any type of power draw, nor is it powerful enough to recharge a discharged battery.
Airxcel, Inc. RV Products Division P.O.
