Unit installation

2
TABLE OF CONTENTS
1. Warnings ..........................................................................2
2. Component Match-Up ................................................................2
3. Unit Depiction Figures ...............................................................3
4. Blower Performance Data ............................................................5
5. General Information .................................................................5
6. Unit Installation .....................................................................5
7. Duct Mounting and Configuration ......................................................6
8. Duct and Register Specifications ...................................................... 7
9. 115 VAC Electrical Wiring ............................................................8
10. Thermostat and 12 VDC Wiring ........................................................9
11. Checkout .........................................................................11
1. WARNINGS
IMPORTANT NOTICE
These instructions are for the use of qualified individuals
specially trained and experienced in installation of this type
equipment and related system components.
Installation and service personnel are required by some states
to be licensed. PERSONS NOT QUALIFIED SHALL NOT
INSTALL NOR SERVICE THIS EQUIPMENT.
NOTE
The words “Shall” or “Must” indicate a requirement which is
essential to satisfactory and safe product performance.
The words “Should” or “May” indicate a recommendation or
advice which is not essential and not required but which may
be useful or helpful.
WARNING
DO NOT PERFORM A DIELECTRIC
STRENGTH TEST (HYPOT) ON 6536
SERIES HEAT PUMPS. DAMAGE
TO PRINTED CIRCUIT BOARD MAY
RESULT.
WARNING - SHOCK HAZARD
To prevent the possibility of severe personal injury or
equipment damage due to electrical shock, always be sure the
electrical power source to the appliance is disconnected.
CAREFULLY FOLLOW ALL INSTRUCTIONS AND
WARNINGS IN THIS BOOKLET TO AVOID DAMAGE TO
THE EQUIPMENT, PERSONAL INJURY OR FIRE.
WARNING
Improper installation may damage equipment, can create a
hazard and will void the warranty.
The use of components not tested in combination with these
units will void the warranty, may make the equipment in
violation of state codes, may create a hazard and may ruin the
equipment.
2. COMPONENT MATCH-UP
1. 6536 Series Two Ton Packaged Heat Pump.
(Reference specifications for model number
breakdown and identification.)
2. 6536-3451 or 6536-3351 Electronic 12 VDC Wall
Mounted Thermostat. This thermostat is pre-wired to
two electrical connectors. Both the thermostat
supply and control wiring can be quickly attached
(plugged in) to the thermostat.
3. 6795C4351 35' thermostat cable with connector plugs
for termination at both the heat pump and electronic
thermostat.