Service manual

12. BY-FLOW RESTRICTOR REPLACEMENT

1. Remove top panel.

2. Remove Section C (See Figure 11).

3. Remove outdoor blower. Follow steps 1-4 in Outdoor

Blower Motor Removal Section.

4. Be certain at this point that the refrigerant charge has

been removed from the system/systems being

serviced.

Remove clamps holding restrictor in place

(See #17, Figure 12).

6. Unbraze by-flow restrictor from points 16. Make note

of plumbing locations for new restrictor. Must be

installed in same manner. (Note to protect any wiring

that could come into contact with the torch flame or

heated copper lines.)

Note: Upon reassembly, the references made on

Figures 11 and 12 shall be used for proper

reassembly. The assemblies shall be

secured with wire ties in order to prevent

excess chafing and vibration.