Installation Guide

ManualsBrandsRuvati ManualsDrop-in Kitchen Sinks30 x 22 in. Workstation Drop-In Tight Radius Topmount 16-Gauge Ledge Stainless Steel Kitchen Sink Single Bowl

UVATI USA

ww.ruvati.com

Dimensions

Topmount Stainless Steel

Workstation Sink Single Bowl

Model

Number Width Length Depth

RVH8030

30" 22”

10”

ev 12/11

rinted in USA

Page 1

Features

In the Box

•

Sink

•

Wood cutting board

•

Stainless Steel deep colander

•

Stainless steel and silicone roll-up dish drying rack

•

Bottom rinse grid, basket strainer drain assembly

•

Mounting brackets and cut-out template

• 16 gauge stainless steel

• Premium 304 grade stainless steel

(18/10 Chromium/Nickel)

•

Commercial grade brushed finish

• Heavy duty sound guard padding and

undercoating

• Slanted bottom with elegant drain

grooves for easy draining

• Tight radius corners for easy cleaning

• Drain placement - Rear

•

Workstation sink - ledges on front and

back act as a track for accessories

•

Pre-drilled with two standard 1-3/8"

holes for faucet and soap dispenser

RVH8030

Summary of content (4 pages)

PAGE 1
RVH8030 ® Topmount Stainless Steel Workstation Sink Single Bowl Features • • • • • • • • • 16 gauge stainless steel Premium 304 grade stainless steel (18/10 Chromium/Nickel) Commercial grade brushed finish Workstation sink - ledges on front and back act as a track for accessories Heavy duty sound guard padding and undercoating Slanted bottom with elegant drain grooves for easy draining Tight radius corners for easy cleaning Drain placement - Rear Pre-drilled with two standard 1-3/8" holes for faucet and
PAGE 2
RVH8030 ® Attention Installer 1. Read these instructions carefully before installation. Inspect sink for damages. Do not install if the sink is damaged. 2. Ruvati recommends that installation of undermount sinks be done by a professional installer. 3. Sink edges may be sharp and can cause accidental injury to installer if not careful. Wear cut-resistant protective gloves during installation. 4. Templates are only provided as a guide.
PAGE 3
RVH8030 ® 4. Attach mounting clips to the prongs protruding from the underside of the sink rim. Make sure the hooked side of the mounting clip is facing away from the sink (Figure 3). 5. Before installing the sink, place a bead of plumbers putty along the edge of the drain opening inside the sink and press the strainer body into place. Turn the sink upside down and tighten the strainer locknut with a wrench. While tightening, hold the strainer steady with pliers the keep it from turning.
PAGE 4
RVH8030 ® Care and Maintenance • Clean regularly with normal detergent and warm water. • Always make a habit of drying your sink after use and buffing with a soft cloth. This will ensure that no build up of limescale or other mineral deposits can occur. • Clean the sink once a week using a nonabrasive cleanser such as Comet and a clean soft sponge. Scrub in the same direction as the natural grain of the sink. • Never let soap or other household cleaners to dry on the surface of the sink.