User's Manual

Table Of Contents

Ruuvi Gateway user manual

1) Open product package

2) Connect antenna

3) Connect with an Ethernet cable to your internet router

4) Connect power source

5) Ready.

If you would like to use Wi-Fi to connect to your local area network, power on the

Gateway without plugging the Ethernet cable. Then, join a Wi-Fi hotspot named

“RuuviGatewayXXXX”, enter IP address “10.10.0.1” using your favourite internet browser

and follow on-screen instructions.

Additional instructions can be found on ruuvi.com

PAGE 1
Ruuvi Gateway user manual 1) 2) 3) 4) 5) Open product package Connect antenna Connect with an Ethernet cable to your internet router Connect power source Ready. If you would like to use Wi-Fi to connect to your local area network, power on the Gateway without plugging the Ethernet cable. Then, join a Wi-Fi hotspot named “RuuviGatewayXXXX”, enter IP address “10.10.0.1” using your favourite internet browser and follow on-screen instructions. Additional instructions can be found on ruuvi.
PAGE 2
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.