Technical Specifications

Features & Benefits
Power Vent commercial gas water
heaters are available in 75,100 Btu/h,
with a maximum temperature setting
of 160 degrees Fahrenheit and vent up
to 95 equivalent feet. This water heater
is specifically designed where medium
quantities of hot water are required.
Typical applications include large resi-
dences, small restaurants, apartments
up to six units and small office buildings.
Thermal Efficiency
Meets or exceeds a minimum of 80%
(non-condensing)
Superior Tank Design
Proprietary steel formulation with
a unique coat of high temperature
porcelain enamel to maximize corrosion
resistance.
FVIR Compliant
Maintenance free with no filter to clean.
Flammable Vapor
Detection Sensor
A protective control
system disables the
heater in the presence
of flammable vapor
accumulation.
Self-Diagnostic System
Integrated self-dianostic system control
takes the guess work away.
Integral Automatic Blower
The powered blower assists in quietly
bringing in combustion air and
discharging combustion gases using
110 volt electrical connection.
Low Emissions
Environmentally friendly burner is
40 ng/J NOx compliant.
Easier, Less Costly Venting
Installs with PVC, ABS, or CPVC vent
options with vertical or horizontal
termination. Side connections are
available for ease of installation and
flexibility. Maximum vent length is 95
equivalent feet using 4” PVC; Vents
up to 35 equivalent feet using 3” PVC
pipe. For Canadian installations, use
ULC-S636 PVC and CPVC pipe.
Longer Life
A patented magnesium anode rod
design with resistor protects the tank
from corrosion.
Hot Surface Ignition (HSI)
Less fuel consumption versus a
standing pilot
Self Cleaning
Fights sediment buildup to increase
operating efficiency and extend tank life.
Full-port, Full-flow Drain Valve
Factory installed brass drain valve
allows for faster draining and servicing.
CSA/ASME Rated T&P Valve
Factory installed relief valve
Altitude Certification
Certified up to 8,500
Warranty
3-Year limited tank warranty and
1-Year limited parts warranty
See Commercial Warranty Certificate for
complete information
Efficiency | These models have been tested
according to DOE test procedures, and meet
or exceed thermal efficiency and standby loss
requirements of current ASHRAE standards (Part of
the Federally mandated Energy Policy Act (EPact) and
NRCAN). Also exceeds energy efficiency codes of all
states including California Energy Commission (CEC).
Safety and Construction | Design certified by CSA
Laboratories: a) To meet all safety and construction
requirements of ANSI Z21.10.1. b) As an automatic
storage water heater. c) For operation of combustible
floors, in alcove, and closet installations. d) For
combination water heating and space heating
applications. All models are North Carolina code
compliant. Certified for 150 PSI maximum
working pressure.
Power Vent commercial water heaters are designed
for wherever medium duty quantities of hot water
are required and offer up to 95 feet vent runs
Ruud
Power Vent
75-Gallon Capacity
75,100 Btu/h
Natural and LP Gas
Ruud Commercial Gas
Power Vent Water Heaters
Ruud Water Heating • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.ruud.com
PRINTED IN U.S.A. 10/15 WP FORM NO. RR102C-4R Rev. 4
See specifications chart on back.