Compatibility Chart

DIY DOOR SYSTEM Assembly Instructions
8
Figure 1
Figure 2
3’ (feet)
or 36”
(inches)
PULL INSTALLATION
1. Lay the door (A.) facing up on a clean,
stable surface.
2. Measure 3’ (feet) or 36” (inches) from
the bottom of the door to where the
center of the pull will be (see NOTE
above). Using a pencil, lightly draw a
vertical line on the wood.
3. Lay the Door Pull(M.) on the surface
of the wood, centering the pull on the
pencil line. Using a pencil, mark the
placement of the pull’s screw holes on
the door. Set the pull aside (Figure 1).
4. Using a drill with an 1/8” bit, drill
each mark, being careful to not drill
through the door (Figure 2).
5. Using a drill with a phillips bit, attach
the door pull using phillips head screws
(D.).
e center point of the door pull
should be three feet or 36” above
the bottom edge of the door.
Avoid placing the door pull too
close to the edge of the door.
Placing the pull too close to the
edge can damage both door and
pull.
NOTE