Compatibility Chart

DIY DOOR SYSTEM Assembly Instructions
5
Figure 1
Figure 2
Figure 3
3/16”
3/4”
Figure 4
Depth of cut
NOTE:
Ensure the bottom slat is tall enough
to accept a 3/4” groove.
PREPARING BOTTOM SLAT
1. Select the slat that will be the bottom
slat of the door (Figure 1).
2. Using a tape measure and pencil,
draw a vertical line on the end of the
slat, ensuring the line on the slat is
in line with the slot in the metal stile
(Figure 2).
4. Set the table saw blade to a 3/4” depth
(Figure 4).
5. Set the fence to cut just inside one of
the outer lines (Figure 4).
3. Draw two vertical lines, one on each
side of the rst line, 3/16” away from the
rst line (Figure 3). is will show the
area to cut away with the table saw.
6. Run the saw blade through the
bottom of the slat, repeating the process
and moving the fence until the width of
the groove equals 3/8”.