Installation Guide

KINGSHIP HANGER Assembly Instructions
RUSTICAHARDWARE.com
4
3
03
2017
VERSION
NOTE:
Doors using Floor Mount Door Guides
will have a groove on the bottom. Ensure
this groove is on the opposite end of the
Door Hanger Installation.
2-3/8”
Installation
Holes
2”
1. Lay the door with the front facing up on a at,
level surface.
2. Place the hanger on the door (Figure 1).
3. Adjust the placement of the hanger for a 2-3/8”
gap between the top of the door and the bottom
edge of the wheel. Ensure the widest portion of
the hanger resting on the door is 2” from the edge
of the door (Figure 2).
Figure 1
Figure 2
4. Mark the center of each installation hole with a
pencil. (Figure 2).
5. Repeat steps 2-4 for the opposite end of the
door. Set the hangers aside.