Installation Guide

RUSTICAHARDWARE.com
3
03
2017
VERSION
MOUNTAIN MODERN Installation Instructions
10
�
Figure 1
DOOR INSTALLATION
Figure 3
Figure 4
DOOR GUIDE INSTALLATION
4. Slide the door to the open position (Figure 4).
SUGGESTION:
Use double stick tape on the back of the Door Guide
to hold the guide in place.
5. Align the door guide (K.) slightly below the
door’s bottom edge ensuring the door can slide
through the guide without scraping.
6. Install the Door Guide with two #6x1-1/4”
Flat Head Wood Screw (E.) using a drill with a
phillips bit.
1. Hang the door on the track
(Figure 1).
NOTE:
If the door does not slide freely through the
guide, adjust the width of the guide by loosening
the screw on the outside bracket. Slide the bracket
to the appropriate position, then tighten the screw
on the outside bracket.
ANTI-JUMP BLOCK INSTALLATION
2. Install the anit-jump block (J.) on the back
of the hanger using the provided socket screw
(Figure 3).
3. Repeat for the opposite end of the door.