Installation Guide

KINGSHIP HANGER Track & Door Installation Instructions
RUSTICAHARDWARE.com
9
3
03
2017
VERSION
ANTI-JUMP GUIDE INSTALLATION
SUGGESTION:
Use double stick tape on the back of the anti-jump
bracket to hold it in place on the door.
18. Install the bracket to the door edge with 2
phillips screws (provided) using a drill with a
phillips bit (Figure 9).
17. Place the Anti-Jump bracket on the door
side, moving the bracket up until it is between
1/8” and 1/16” from the bottom edge of the rail.
Mark the placement with a pencil.
19. Repeat steps 17 and 18 for the opposite end
of the door.
Figure 9