Installation Guide

R H
•••••••••••••••••••••••••••••••••••••••••
INSTALLATION INSTRUCTIONS
INSTALLING GUIDE
1. Aligning Anti-jump Bracket
• With your Door still hanging
on the Track, place your
Anti-jump Bracket against
the outside edge of your
Door.
• Slide the Bracket up until
there is a 1/16” to 1/8” space
between the top of the
Anti-jump Bracket and the
bottom of the Track.
2. Installing Anti-jump Bracket
• Holding the Anti-jump
Bracket rmly in place, drill
Grabber Screws into each
of the two holes in the
Bracket until screw heads are
ush with your Bracket.
Installing this Bracket will
ensure your Door will not
come o its Track.
• Repeat Steps 1 and 2 on
the opposite edge of
the Door.
On Square-Edged Doors
On Curved-Edged Doors Modern Range and Bodyguard Style Doors
• With your Door still hanging on the Track,
pull your Door out into the open doorway so
you can access the back of your Door.
• Place the Anti-jump Bracket against the back
of the Door, with the small edge on the top
of the bracket going over the Door top.
Be careful not to align the holes in the
bracket over the screws attaching your
Hanger to the Door.
Wall
Doorway
Door Back
• Slide the Bracket upward so there is a
1/16” to 1/8” space between the top
of the Anti-jump Bracket and the
bottom of the Track.
• Holding the Anti-jump Bracket
rmly in place, drill grabber
screws into both of the holes
in the Bracket using a Phillips
bit. Installing this Bracket
will ensure your Door will
not come o its Track.
• Repeat Steps 1 and 2 on the
opposite edge of the Door.
1. Aligning Anti-jump Bracket
2. Installing Anti-jump Bracket
Track
Bracket
Against
Door
Back
Back
side
facing
you
Back
side
facing
you