Installation Guide
R H
•••••••••••••••••••••••••••••••••••••••••
INSTALLATION INSTRUCTIONS
PARTS AND TOOLS
www.rusticahardware.com
}
}
1/2”
• To determine where to install your Track, add together 2-9/16” 
  (space above door) plus 1/2” (oor gap) to the height of
  your Door. This measurement is how high up on your wall 
  (from your finished floor up) you should install the Track.
• Take into consideration while hanging doors onto your Track, 
  the bottom of the door must not be more than 1” off the ground 
  or the door will ride too high and miss the Door Guide.
• This is where you will mark a horizontal line on your wall 
  parallel to the floor, slightly longer than the length of your Track. 
  Use a level to ensure the horizontal line is completely level.
• Check to see if your floor is level. If your floor rises more than   
  1/2” along the length of the Track, you risk your Door rubbing 
  or sticking at this high point. 
• If your floor is not level, measure up from the highest point of 
  your finished floor to find your Track hole center position 
  to attach the Track to your wall.
1. Measuring for Track Position
Door 
Height
2-9/16”
2-9/16”
Door Height
1/2” 
+
+
=
}
# of inches up from nished oor where you will 
pencil a horizontal line for your Track. This line 
will mark the center of the Track and your pen-
ciled line will be visible trough the Track holes.
Assembly Instructions
3. Marking Pilot Holes
•  Continue your penciled line onto the header. Lay your 
  Track onto your Header and mark for hole locations to
  attach the Track to the Header.
2. Installing the Header
•  After you have marked for proper Track location, mark for drill 
  holes for attaching the Header, making sure you are attaching the 
  Header into your wall studs using Long Grabber Screws. is is 
  important to ensure your wall can hold the weight of your Track
  System and Door. Use your level to ensure the track is level.
IMPORTANT!
A Header is included in your order for your conve-
nience and for solid installation. Without a Header, 
four of your Track holes must line up with studs. 
Otherwise, the weight of your Track System and Door 
will be too heavy and could pull out of your drywall, 
which could result in damage or injury.
! !
page 3





