Installation Guide

Installation de la piste
Installing a Header
2. Hanging Your Track
 e end holes will be
installed with a Hard
Stop.
 In this order: Adjustable Spacer,
Flat Track, Hard Stop, 1” Washer,
and Lag Screw.
Using a ratchet with a 9/16”
socket, tighten the Lag Screw
most of the way, enough to hold
the Track in place, but allowing
the Track to move.
 Swing the Track up to be
horizontal, and repeat the same
step on the opposite end of the
Track.
 e hardware for the middle holes will
be installed in this order: Adjustable
Spacer, Flat Track, 1” Washer, and Lag
Screw. Using a ratchet with a 9/16” socket,
tighten the Lag Screw most of the way.
 Repeat on all remaining middle Track
holes.
 After all Lag Screws are in, fully tighten
all using your ratchet with socket, being
careful not to over-tighten to avoid
stripping the wall studs.
9/16”
 Loosely attach one end of the Track
using a Spacer and a Hard Stop or a
Lag Soft Stop (see below).
 Swing the Track up and loosely
attach the other end, using a Spacer
and a Hard Stop or a Lag Soft
Stop (see below).
 e center holes can now be loosely
attached (see below).
9/16”
3. Hole Installation
Installing the Track