Installation Guide

Installation d'un en-tête
Measuring for your Track holes
On your Header, measure in 3” from the
end and 4“ from the top and 2” from the
bottom of the header.
4”
3”
2”
4”
3”
2”
Your Header is ready for your
Track System to be installed.
Attaching Header
Place your Header onto your wall with
the bottom 2” of the Header below your
marked track line. Have someone hold the
Header in place while you continue your
pencil line for the holes in your Track from
your wall onto the Header. Ensure your
line is plumb using a level.
Mark for holes to be drilled making sure
you will be drilling into studs. Drill 1/8”
diameter pilot holes through the Header.
Attach Header to the wall with 3” Grabber
Screws and a drill.
Track holes center
over marked line
for Track location
Doorway
Header
Wall stud
markings
Installing a Header
} 2”