Installation Guide

BUCK HANGER Assembly Instructions

RUSTICAHARDWARE.com

2017

VERSION

2-3/4”

Door Front

Door

Side

Door

Top

INSTALLATION FOR CURVE-EDGE DOORS

1. Place the hanger on the top surface of the door, 2-3/4”

from the edge of the door side and ush with the door

front. Ensure the front of the hanger and the front of the

door are facing the same direction (Figure 1).

Figure 1

2. Using a pencil, mark the screw hole placement on the

door top.

3. Repeat steps 1 and 2 for the opposite end of the door.

Figure 2

4. Drill two pilot holes for each hanger using an 1/8”bit

(Figure 2).

5. Attach the hanger to the door using two fastener screws

(provided). Repeat the process on the opposite end of the

door (Figure 3).

Figure 3

NOTE:

If the door is 3 or more inches thick, mount the hanger

in the center between the front and back of the door.

NOTE:

Doors using Floor Mount Door Guides

will have a groove on the bottom. Ensure

this groove is on the opposite end of the

Door Hanger Installation.