Manualshelf

Installation Guide

ManualsBrandsRustica Hardware ManualsBarn Doors42 in x 84 in Mountain French Steel and Clear Full lite Glass Barn Door with Sliding Hardware Kit and Left Hand Pull
12345678910
BUCK HANGER Assembly Instructions
RUSTICAHARDWARE.com
4
3
03
2017
VERSION
Door Front
Door
Side
1. Place the hanger on the top surface of the door, 2” from
the edge of the door side and ush with the door front.
Ensure the front of the hanger and the front of the door are
facing the same direction (Figure 1).
INSTALLATION FOR SQUARE-EDGE DOORS
NOTE:
Doors using Floor Mount Door Guides
will have a groove on the bottom. Ensure
this groove is on the opposite end of the
Door Hanger Installation.
Figure 1
2. Using a pencil, mark the screw hole placement on the
door top.
Figure 2
NOTE:
If the door is 3 or more inches thick, mount the hanger
in the center between the front and back of the door.
Door
Top
3. Repeat steps 1 and 2 for the opposite end of the door.
4. Drill two pilot holes for each hanger using an 1/8”bit
(Figure 2).
2”
5. Attach the hanger to the door using two fastener screws
(provided). Repeat the process on the opposite end of the
door (Figure 3).
Figure 3