Installation Guide

BUCK HANGER Track & Door Installation Instructions
RUSTICAHARDWARE.com
9
3
03
2017
VERSION
Figure 9
Figure 10
ANTI-JUMP GUIDE INSTALLATION FOR SQUARE-EDGE DOORS
ANTI-JUMP GUIDE INSTALLATION FOR CURVE-EDGE DOORS
SUGGESTION:
Use double stick tape on the back of the anti-jump
bracket to hold it in place on the door.
SUGGESTION:
Use double stick tape on the back of the anti-jump
bracket to hold it in place on the door.
18. Install the bracket to the door edge with 2
phillips screws (provided) using a drill with a
phillips bit (Figure 9).
21. Install the bracket to the back of the door
with 2 phillips screws (provided) using a drill
with a phillips bit (Figure 10).
17. Place the Anti-Jump bracket on the door
side, moving the bracket up until it is between
1/8” and 1/16” from the bottom edge of the
track. Mark the placement with a pencil.
19. Repeat steps 17 and 18 for the opposite end
of the door.
22. Repeat steps 20 and 21 for the opposite end
of the door.
20. Place the Anti-Jump bracket on the door
back, moving the bracket up until it is between
1/8” and 1/16” from the bottom edge of the
track. Mark the placement with a pencil.