Installation Guide

R H
•••••••••••••••••••••••••••••••••••••••••
INSTALLATION INSTRUCTIONS
ATTACHING HANGER
2-3/4”
On Curved-Edged Doors Modern Range and Bodyguard Style Doors
1. Measuring And Marking Your Hanger Holes 2. Drilling Pilot Holes
1/8”
Door Back
Door Top
Door Front
Door
Edge
• Using a drill with a
1/8” bit, drill two pilot
holes (one pilot hole for
each hole in the Hanger).
• Repeat Step 2 on the
opposite edge of the Door.
Door Back
Door
Edge
Door Top
• Place your Top Mount Hanger up against the top
of your Door, making sure the Hanger front and
the Door front are both facing the same direction.
• Measure 2-3/4” from the outside edge of your
Door to the Hanger base. (also, see below).
• With a pencil, mark the center of both Hanger
holes (these indicate where you should drill to
attach your Hanger to your Door).
• Repeat Step 1 on the opposite
edge of the Door.
Back of
Hanger
Door Top
Door Edge
2-3/4”
2-3/4”
3. Installing Your Hanger Assembly To Your Door
• Place the Hanger back
onto the top of your
Door, with the holes
centered over the pilot holes.
Make sure your Hanger and your Door
are both facing the same way.
• Place a Fastener Screw tip into a pilot hole. Drill
the Fastener Screw down into your door using a
Phillips bit. Repeat for the other Fastener Screw.
• Repeat Step 3 on the opposite edge of the Door.
Door Back
Door Top
Door
Edge
Back of Hanger