Installation Guide

R H
•••••••••••••••••••••••••••••••••••••••••
INSTALLATION INSTRUCTIONS
HANGER HOLES
2
"
2
"
• Lay your Door
facing UP on saw horses.
• Measure a 2-3/8
”
gap
between the top of the Door and the
bottom of the Wheel (see below also).
• Pencil a mark 2” parallel from the Door
edge to the Hanger edge. Repeat below
aligning the point near the arrow bottom to
the 2” mark.
• Check to see there is still a 2-3/8
”
gap between the top
of the Door and the bottom of the Wheel (see below).
(this marks the proper location for the Hanger edge).
• Mark the center of both Hanger holes (these indicate
where you should drill to attach your Hanger to your Door).
• Repeat Step 1 on the opposite Door edge.
2
1/2”
1. Measuring and Marking Your Hanger Holes
• Using a drill with a 1/8”
bit, drill a pilot hole all
the way through the Door
where you have marked.
(one pilot hole for each
hole in the Hanger).
• Repeat Step 2 on the opposite
edge of the Door.
Door Edge
Door Front
Door Top
• Lay the Door facing DOWN on the saw horses.
• Using a drill with a 1” spade bit or Forstner bit
(a Forstner bit is preferred), drill a 7/16” deep hole,
centering your 1” spade or Forstner bit directly over
the 1/8” pilot hole.
• Repeat Step 3 on the opposite edge of the Door.
2. Drilling Pilot Holes
3. Drilling Countersink Holes 4. Drilling Lag Screw Holes
• Lay the Door facing UPWARDS on the saw horses.
• Using a drill with a 3/8” drill bit, drill all the way
through the Door, through your pilot holes (Step 2).
• Repeat Step 4 on the opposite edge of the Door.
1/8”
1”
3/8”
Door Edge
Door Front
Door Top
Door Edge
Door Back
Door Top
Door Front
Door Top
Door Top
Door Edge
2-3/8”