Installation Guide

Page 8

Slide all C Slats into A1 R and A3 grooves. Once

all of the slats have been positioned, place the A4

Top Rail onto the C slats and in the A1 R grooves.

Fasten A4 into place with a Timberlock, rst with

your hand, then tighten with a ratchet. Be sure

the Timberlock is going straight in and not at an

angle. Fasten by hand, then with a ratchet.

Slide Side Slat A1 L into place, attaching with 6”

Timberlocks, tightening by hand. Once you have

determined all are in place straight, tighten

Timberlocks with a ratchet.

When the Door is

assembled, place

A5, A6 and A7 (Top

Diagonal Rails)

onto the door so

the predrilled holes

are facing up and so

they form an X that

runs from corner to

corner. Attach using

the 1-1/4” Grabber

Screws and a drill

with a Phillips bit.

Repeat for B5, B6,

and B7 (Lower

Diagonal Rails).

Attach the Door Pull

and your Door is

ready to hang.

C2 C2

Double X Door